Description Compatibility with Rega brand TT/TA REGA brand cartridges’ height from stylus tip to the top cartridge mounting surface is lower than standard. Therefore you would need spacers to ensure the correct set-up of the Ortofon cartridge. Adjusting the height of your Rega tonearm is easy It allows you to adjust the height from 0.5 mm to 3.5 mm in precise steps of 0.5 mm – without removing the tone arm. Simply loosen the screws, insert the AS-spacer, then lock the screws back down, and you’re tonearm is ready to play. 3.2 – 4 mm spacers should be enough for Quintet cartridge.MC Quintet Blue Technical dataOutput voltage at 1 kHz 5 cm/sec – 0.5 mV Channel balance – < 1.5 dB Channel separation at 1 kHz – > 21 dB Channel separation at 15 kHz – > 14 dB Frequency range at -3 dB – 20-25.000 Hz Frequency response 20-20.000 Hz – /-2.5 dB Tracking ability at 315 Hz at recommended tracking force *) – 70 μm Compliance, dynamic, lateral – 15 μm/mN Stylus type – Nude Elliptical Stylus tip radius – r/R 8/18 μm Tracking force range – 2.1-2.5 g (21-25 mN) Tracking force recommended – 2.3 g (23 mN) Tracking angle – 20º Internal impedance, DC resistance – 7 Ohm Recommended load impedance – >20 Ohm Cartridge body material – ABS/Aluminium Coil wire material – Pure 4-nines copper Cartridge colour – Blue Cartridge weight – 9 g
